READ ALONGSIDE THE SOURCE
Okaloosa County BOCC — October 5, 2013 — 7SFG — reading text
Part 6 of 8. These parts divide the reading text for browsing; they are not the source document's page numbers.
Machine-extracted text — 92-7SFG.pdf
Machine-extracted OCR text · Review label: Machine produced / unreviewed
Compare this copy with the preserved source. Review labels describe the recorded status of this file; they do not guarantee that the text is error-free. Spacing and line breaks are retained, with long lines wrapped to fit the screen.
Sweeps. Where a bend or sweep is placed in PVC nonmetallic duct bank
between manholes, the duct bank must be encased in concrete with a minimum compressive
strength of 17,225 kilopascal (kPa) [2500 pounds per square inch (psi)].
2.3.9. Labeling. The contractor shall label all equipment and cables they install in accordance with
ANSI/TIA/EIA-606-A-2002 and as directed by the base communications organization. New
ducts shall be permanently labeled on the wall of each building/manhole indicating the
connecting building/manhole at the other end of the duct (for example, “To MH-200”).
2.3.10. Bonding. Shield bonding connectors, bond bars, braids, ribbons, clamps, etc., shall be
provided to maintain cable shield continuity at splices and at ground connections. Bonding
connectors shall be provided [AW RUS Bulletin 1753F-803 (PE-33). Shields shall be
grounded and continuous throughout the cable distribution system.
2.3.11. Grounding. The contractor shall ground new copper cable to the Telecommunication Main
Ground Bus-Bar (TMGB), in or near the new service entrance box located on the outside of
each building. The contractor is required to provide one 6’ X 4’’ copper ground bar and
ground it to the existing ground point in accordance with ANSI-J-607-A-2002, sections 5 and
6, unless a TMGB already exists.
2.3.12, Cable Terminations. Fiber optic cables shall be terminated by being fusion spliced to
factory simplex pigtails with SC connectors. Intermediate cable splices should be minimized,
and consist of fusion splices in a high quality re-enterable splice case. A dry type
encapsulant shall be used to seal fiber splice cases.
2.4. Outside Plant Installation. This section describes the general outside plant installation.
The sequence of installation is at the contractor’s discretion.
2.4.1. Manhole and Duct System Installation.
N/A
2.4.2. Fiber Optic Cable Installation. Install outside plant fiber optic cable (FOC) as described
below.
2.4.2.1. A 36-strand all-dielectric fiber optic cable shall be installed from building 4545 to
PB 9406 located near the county lift station on the north end of the compound. The installation shall
utilize the existing manhole and duct system from building 4545 to manhole SFG 27.
2.4.3 Sheath Limitations
If the OSP sheath distance from the building entrance point to the PET or FO connector housing
location is greater than 50 cable feet (15 m), the use of EMT or a splice case with transition to riser-
rated cable is required.
3 CONTRACTOR REQUIREMENTS
The contractor shall:
@ Shall provide all personnel, equipment, tools, materials, supervision, and services necessary
to perform this project.
e Order all supplies to complete the project that is already not Government Furnished.
® Store all supplies throughout the project.
4 TASKS
The contractor shall complete the following tasks during the project:
e Install 36-strand all-dielectric single mode fiber optic in locatable pipe as required to meet the
scope of work.
Coordinate with the base comm. Plans and Programs office.
Test all cables that are installed under this project. Fiber optic cable shall be tested for dB
loss end-to-end, bi-directionally through patch cables.
© Conduct a final walk-through/inspection with the base contracting rep, 96 CS Cable
Maintenance rep and the 96 CS/SCXP rep. The contractor will fix any discrepancies
identified in the walkthrough if needed. :
e Provide an in-depth test plan to include standards being used, test equipment being used and
other pertinent data as required by TIA/EIA standards and the Eglin AFB Cable and Wire
Specifications, dated March 2013.
5 DELIVERABLES
The contractor agrees to the following deliverables:
vinta on a
e Provide all test results to the 96 CS Plans and Programs Flight rep. The test results provided
to Plans and Programs rep should be delivered to the Cable Maintenance rep.
e All cables will be labeled and tagged IAW applicable standards and technica! orders.
Information on cable identifiers will be identified/provided by 96 CS/SCOW personnel. All
cables will be grounded IAW applicable standards. Upon completion of the project, base
layout drawings will be updated by the contractor and provided as a deliverable item on this
contract. Updated drawings are to indicate GIS/GPS coordinates, cable path, cable
designator and any other pertinent information as related to this installation.
6 PERIOD OF PERFORMANCE & COSTING:
N/A
7 PLACE OF PERFORMANCE
Building 4545, 7th SFG compound, North Gate of Eglin AFB, FL.
8 TRAVEL ;
Travel onto Eglin AFB to job locations will be the sole responsibility of the contractors and must not
hinder the project’s completion. Payment for travel will not be part of the contract if the contractor is
in the local area.
9 CLASSIFICATION/SECURITY
Contractors are not required to have any security clearances but should meet the initial requirements
in the Contractor Requirements section above.
10 GOVERNMENT FURNISHED PROPERTY
None.
11 WARRANY
Once the project is complete and all work has been accepted, the contractor’s obligation for the
installation is complete and no further support is needed. The 96 CS will continue to provide all
future technical support for any needed maintenance or repairs to the cabling that is installed from
PB 5270 to Bidg 44 and PB 9406 to Bldg 4545. Any work required due to warranty on the fiber
from PB 5270 to PB 9406 shall be accomplished by the county or their authorized communications
contractor under the terms of the warranty. Any alteration, maintenance, or changes to the fiber
between PB 5270 and PB 9406 by the Government will void the warranty.
12 PRINCIPLE POCS
96 CS/SCXP Contacts:
MSgt Harley Campbell
Voice: 882-3118
Email: harley.campbell@eglin.af.mil
Mr. Christopher Dunham
Voice: 882-5004
Email: christopher.dunham@eglin.af.mil
96 CS/SCOW Contacts:
Mr. Marcus Sparks
Voice: 882-6948
EMAIL: marcus.sparks@eglin.af.mil
Mr. John Pasternak
VOICE: 882-6947
EMAIL: john.pasternak@eglin.af.mil
Mr Stephen Preble
VOICE: 882-6946
EMAIL: stephen.preble@eglin.af.mil
7SFG (A) S86 Contacts:
CW3 Braun, Robert
robert.braun1@soc.mil
850-885-7264
CW2 Guardiola, Luis
luis.guardiolaparrilla@soc.mil
850-885-7265
Mr Randal Collinsworth
randal.collinsworth@eglin.af.mil
Randal.collinsworth@us.army.mil
Randal.collinsworth@ahqb.soc.mil
13 PAYMENT SCHEDULE
The contractor will bill upon completion.
8
14 NON-PERSONAL SERVICES STATEMENT
Contractor employees performing services under this order will be controlled, directed, and
supervised at all times by management personnel of the contractor. Contractor management will
ensure that employees properly comply with the performance work standards outlined in the
statement of work. Contractor employees will perform their duties independent of, and without the
supervision of, any Government official or other Defense Contractor. The tasks, duties, and
responsibilities set forth in the task order may not be interpreted or implemented in any manner that
~ results in any contractor employee creating or modifying Federal policy, obligating the appropriated
funds of the United States Government, overseeing the work of Federal employees, providing direct
personal services to any Federal employee, or otherwise violating the prohibitions set forth in Parts
7.5 and 37.1 of the Federal Acquisition Regulation (FAR). The base contracting representatives and
the base communications representatives will all need to be present and perform the final inspection
and acceptance of the completed work.
(ct Page | of 10
WD 05-3033 (Rev.-13) was first posted on www.wdol.gov on 06/25/2013
AS SRCLASALELE SSE LSE CASE SESE ESE CSS SS SEC LST ECT EP CES SSCP SSS ETC PITTS SET LSS CTS Le TL eT eS Ty
REGISTER OF WAGE DETERMINATIONS UNDER
THE SERVICE CONTRACT ACT
By direction of the Secretary of Labor
Diane C. Koplewski Division of
Director Wage Determinations
U.S. DEPARTMENT OF LABOR
EMPLOYMENT STANDARDS ADMINISTRATION
WAGE AND HOUR DIVISION
WASHINGTON D.C. 20210
Wage Determination No.: 2005-3033
Revision No.: 13
Date Of Revision: 06/19/2013
State: Florida
Area: Florida Counties of Escambia, Okaloosa, Santa Rosa
**Fringe Benefits Required Follow the Occupational Listing**
OCCUPATION CODE - TITLE
FOOTNOTE
01000 - Administrative Support And Clerical Occupations
01011 - Accounting Clerk I
01012 - Accounting Clerk II
01013 - Accounting Clerk III
01020 - Administrative Assistant
01040 - Court Reporter
01051 ~ Data Entry Operator I
01052 - Data Entry Operator IT
01060 - Dispatcher, Motor Vehicle
01070 - Document Preparation Clerk
01090 - Duplicating Machine Operator
01111 - General Clerk I
01112 - General Clerk II
01113 - General Clerk III
01120 - Housing Referral Assistant
01141 - Messenger Courier
01191 - Order Clerk I
01192 - Order Clerk II
01261 - Personnel Assistant (Employment) I
01262 - Personnel Assistant (Employment) II
01263 - Personnel Assistant (Employment) III
01270 - Production Control Clerk
01280 - Receptionist
01290 - Rental Clerk
01300 - Scheduler, Maintenance
01311 - Secretary I
01312 - Secretary II
01313 - Secretary III
01320 - Service Order Dispatcher
01410 - Supply Technician
01420 - Survey Worker
01531 - Travel Clerk I
01532 - Travel Clerk II
01533 - Travel Clerk III
01611 - Word Processor I
01612 - Word Processor II
01613 - Word Processor III
05000 - Automotive Service Occupations
0500S - Automobile Body Repairer, Fiberglass
05010 - Automotive Electrician
05040 - Automotive Glass Installer
05070 - Automotive Worker
http://www.wdol.gov/wdol/scafiles/std/05-3033.txt?v=13
14.12
15.84
17.72
17.64
17.18
10.89
12.29
14.08
12.11
12.11
11.37
12.41
13.92
16.33
10.35
10.98
13.07
14.24
15.93
17.77
19.11
11.28
13.09
13.09
13.09
14.64
16.33
12.45
17.64
12.91
11.16
11,93
12.71
12.69
14.24
15.93
21.33
20.25
19.43
18.80
9/12/2013
05110
05130
05160
05190
05220
05250
05280
05310
05340
05370
05400
07000 -
07010
07041
07042
07070
07130
07210
072606
09000 -
09010
03040
09080
09090
09110
09130
11000 -
11030
11060
11090
11122
11150
11210
11240
11260
11270
11330
11360
12000 -
12010
12011
12012
22015
12020
12025
12030
12035
12040
120721
12072
12073
12100
12130
12160
12190
12195
12210
12221
12222
12223
12224
Mobile Equipment Servicer
Motor Equipment Metal Mechanic
Motor Equipment Metal Worker
Motor Vehicle Mechanic
Motor Vehicle Mechanic Helper
Motor Vehicle Upholstery Worker
Motor Vehicle Wrecker
Painter, Automotive
Radiator Repair Specialist
Tire Repairer
Transmission Repair Specialist
Food Preparation And Service Occupations
Baker
Cook I
Cook ITI
Dishwasher
Food Service Worker
Meat Cutter
Waiter/Waitress
Furniture Maintenance And Repair Occupations
Electrostatic Spray Painter
Furniture Handler
Furniture Refinisher
Furniture Refinisher Helper
Furniture Repairer, Minor
Upholsterer
General Services And Support Occupations
Cleaner, Vehicles
Elevator Operator
Gardener
Housekeeping Aide
Janitor
Laborer, Grounds Maintenance
Maid or Houseman
Pruner
Tractor Operator
Trail Maintenance Worker
Window Cleaner
Health Occupations
Ambulance Driver
Breath Alcohol Technician
Certified Occupational Therapist Assistant
Certified Physical Therapist Assistant
Dental Assistant
Dental Hygienist
EKG Technician
Electroneurodiagnostic Technologist
Emergency Medical Technician
Licensed Practical Nurse I
Licensed Practical Nurse II
Licensed Practical Nurse III
Medical Assistant
Medical Laboratory Technician
Medical Record Clerk
Medical Record Technician
Medical Transcriptionist
Nuclear Medicine Technologist
Nursing Assistant I
Nursing Assistant II
Nursing Assistant III
Nursing Assistant IV
http://www. wdol.gov/wdol/statites/std/05-3033 txt?v=13
Page 2 of 10
17.06
21.33
18.80
21.33
15.93
18.16
18.80
20.25
18.80
13.79
21.33
11.59
10.08
11.82
7.77
9.09
14.46
10.07
17.32
12.78
17.32
13.62
15.53
17.32
9.37
9.37
14.58
9.89
9.89
10.85
8.86
9.60
12.60
10.85
11.18
15.59
16.21
22.78
23.13
14.96
29.32
22.21
22.21
15.59
14.86
16,86
