READ ALONGSIDE THE SOURCE

Fort Walton Beach Council agenda — 01-24-12 special ldc — reading text

Part 26 of 70. These parts divide the reading text for browsing; they are not the source document's page numbers.

Machine-extracted text — fwb-31233-original.pdf

Machine-extracted OCR text · Review label: Machine produced / unreviewed

Compare this copy with the preserved source. Review labels describe the recorded status of this file; they do not guarantee that the text is error-free. Spacing and line breaks are retained, with long lines wrapped to fit the screen.

area ratio 2. 0 1. 5 None 1. 5 Maximum floor area ratio with bonus provisions' NA 2. 25 NA 2. 25 32, 000 Minimum lot area None None 16,000 f. Minimum lot width ( feet) None None 100 100 Maximum impervious surface (%) 75 75 75 75 Minimum setbacks ( feet) Front card 25 5 50 10 Side yard, interior 15 0 10 0 Side yard, adjacent to a street 25 T5 10 10 NA 20 50 20 Side yard, adjacent to R- 1 E, R -1, or R -2 Rear yard 30 10 20 20 Rear yard, adjacent to R -IE, R -1, or R -2 NA 20 50 30 35 120 50 70 Maximum building height ( feet) See Section 9. 05. 00 for bonus provisions. mmN G. Proposed building height in the MX -2 district shall be analyzed to determine if it exceeds the limitations of the Eglin Air Force Base Tall Structure Analysis Map. In consultation with an Eglin AFB representative, the City may establish the maximum height at less than 120 feet in the MX -2 district, but no less than the maximum structure height ( above mean sea level) causing no major negative mission impacts o 0 for Eglin AFB, as depicted in the Map. 4. 03. 02 Nuisance / Pollution Standards for Industrial Developments All uses and activities conducted in the CTP zoning district shall conform to the standards of performance described below. The failure to conform to any such standards is hereby declared to be a public nuisance. A. Fire and explosion hazards. All activities and all storage of flammable and explosive materials or products at any place shall be provided with adequate safety devices against the hazards of fire and explosion, including adequate firefighting and fire suppression equipment, as prescribed by all applicable fire prevention laws, ordinances, and regulations. B. Radiation. Any operation involving radiation, ( e. g. the use of neutrons, protons and other atomic or nuclear particles) shall be conducted in accordance with the codes, rules, and regulations of State and Federal regulating agencies. Radiation limitations shall not exceed quantities established as safe by the United States Bureau of Deutopmcn, 4a ... lards P,,, 4- I I Ur-cemner 1l- nn I Packet Pg. 75 3. 1. a I IN 11. ItIi % I l Lnnd Ur. dopmem Code 14 ,, 1 rVaIton Deueh Standards. C. Electromagnetic radiation. For the purpose of these regulations, electromagnetic interference shall be defined as disturbances of an electromagnetic nature which are generated by the use of electrical equipment, other than planned and intentional sources of electromagnetic energy, which would interfere with the proper operation of electromagnetic radiation for such purposes as communication, experimentation, entertainment, broadcasting, heating, navigation, therapy, vehicle velocity measurement, weather survey, aircraft detection, topographical survey, personal pleasure or any other use directly or indirectly associated with these purposes which does not comply with the current regulations of the Federal Communications Commission regarding such sources of electromagnetic radiation. Further, said operations, in compliance with the Federal Communications Commission regulations, shall be unlawful if such radiation causes an abnormal degradation of performance of other electromagnetic radiators or electromagnetic receptors of quality and proper design because of proximity, primary field, blanketing, spurious re- radiation, conducted energy in power or telephone systems or harmonic content. The determination of " abnormal degradation of performance" and of " quality and proper design" shall be made in accordance with good engineering practices as defined in the latest principles and standards of the American Institute of Electrical Engineers, the Institute of Radio Engineers and the Radio Manufacturers' Association D. Toxic or hazardous matter. Any activity involving the use or storage of toxic or hazardous matter shall comply with all State, Federal and local laws and all regulations of any Federal, State, or local agency concerning pollution control or toxic substances. E. Waste disposal. No activity shall be conducted which results in the discharge of any liquid or solid waste, including industrial wastes, into any public or private sewage system, the ground, or any lake, stream, or other body of water, in violation of any provision of State, Federal or local law or any regulation of any State, Federal or local agency. F. Vibration. No use of any property shall cause perceptible earth vibrations beyond any property line, except when pilings are driven for structure foundations. All stamping machines, punch presses, press brakes, hot forgings, steam board hammers, or similar devices shall be placed on shock absorption mountings and on suitable reinforced concrete footings. No machine shall be loaded beyond the capacity, as described by the manufacturers. G. Heat, cold, dampness, or movement of air. Activities on any property which produce any adverse effect on the temperature, motion, or humidity of the atmosphere beyond the lot lines are not permitted. H. Glare. There shall be no direct or sky -reflected glare, whether from floodlights, high temperature processing, combustion, welding or otherwise so as to be visible at, or interfere with uses on, adjacent properties. I. Smoke, dust, and particulate matter. There shall be no emission of visible smoke, dust, dirt, fly ash, or any particulate matter from any pipes, vents, or other openings or from any other source, into the air which can cause damage or irritation to health, animals, vegetation or to any form of property or which results in the violation of any applicable Federal, State or local requirements. Pe „ r 1 - 11 1)," u bcr 15, L4I I De' dop count NY en Jards Packet Pg. 76 3. 1. a 1l" Al DR" I Lend Dc, Mallon It, a, 1. J. Odor. There shall be no emission of odorous gases or other odorous matter in such quantities as to be offensive at the points of measurement. Any process which may involve the creation or emission of any such odors shall be provided with both a primary and a secondary safeguard system so that control may be maintained in the event of failure of the primary safeguard system. K. Noise. Reserved. 4. 04. 00 DEVELOPMENT STANDARDS FOR THE RECREATION AND OPEN SPACE DISTRICT 4. 04.01 Site Development Standards The standards for development in the recreation and open space zoning district are provided in Table 4. 04. 01. Table 4.04.01. Development Standards in the Recreation and Open Space Zoning T: enirl Development Feature REC 0. 1 Mostmnm base Door area ratio None Minimum lot area ( square feet) None Minimum lot width ( feet) Maximum impervious surface (%) 40 Minimum setbacks ( feet) Frontyard 25 10 Side yard, interior I5 Side yard, adjacent to street Rear yard 25 35 Maximum building height ( feet) 4. 05. 00 DENSITY AND INTENSITY BONUS PROVISIONS 4.05.01 Purpose and Intent The purpose of this section is to outline the standards for obtaining additional density and floor area above the maximum, but not to exceed one and one -half (1. 5) times the maximum base density and intensity. The bonus provisions set forth are generally intended to offset the added impact that additional density and intensity may have on the environment and the public welfare. 4. 05. 02 Eligibility A. Additional density and floor area beyond the maximum base standards may be Parc4 - 13 WC,' abrr l5. 2011 1) e c alnpnic ai iiandanle Packet Pg. 77 3. 1. a Fort P. Mon Il, a, h I IS ,11: DR ki I

Download this text file with its original spacing ↓